Location and tracking
T8603 model is embedded with GPS and doesn’t have support of GLONASS or alternative systems. It neither supports Assisted GPS technology. As the back-up, when no satellites signals are available, it uses Cell ID location (also known as LBS-tracking).
OBDII data reading
T8603 is a simple tracker. It only gets power supply from OBDII port, but it does not read any data from vehicle CAN bus or K-Line. With T8603 you will be unable to get telemetry from onboard diagnostic system, сheck engine lamp (MIL) or DTC codes.
Mobile networks
With Quad-band GSM module T8603 can be operated in 2G networks all over the world.
Power supply
T8603 uses OBD II Connector Type B (9 of 16 pins used) and voltage range 6-36V, which makes possible to install T8603 both on cars and trucks.
T8603 also features a built-in rechargeable backup battery. When fully charged it ensures about 1-2 hours of device operation (in normal conditions).
When being unplugged from the OBDII socket the device sends notification to server.
Remote management
T8603 tracker can be fully controlled over GPRS, including configuration of tracking modes. There is also a wide list of SMS commands in a human-friendly format, on which device always replies back.
It supports remote configuration of APN settings, server address and port by SMS.
LED Indication
T8603 has two LEDs
- Red LED indicates GSM/GPRS mode
- Blue LED indicates GPS reception
The light goes out automatically in five minutes after the device is plugged into OBDII port.
Additional notes
In some cars it’s not possible to read the Ignition state from the OBDII port. Then T8603 uses proprietary algorithm based on multiple parameters to evaluate the Ignition is ON with 98% accuracy. And the same algorithm it uses to detect the car engine is OFF and reduces the power consumption.
Compared to other OBDII trackers, T8603 seems a little longer. It might cause the device don’t fit the interior details in some cars. To overcome this problem an OBDII extension cable (optional accessory) can be used.
To switch device off (even with charged battery) just remove the SIM card. The device will switch off in 5-10 seconds.
